MINOS PLENA Manual De Usuario página 25

The two positions of the front fork are for fitting 8-, 6- and
5-inch wheels in either of the two positions.
At the top of the fork there are two screws with off-centre hexagonal
faces on the fork side. If the screws are loosened and the position of
the off-centre hexagon is altered, a different angle of inclination of
the fork is achieved. By changing the height of the back wheel, the
fork can be positioned perpendicular to the ground.
The front wheel can be changed using an Allen key.
Unscrew and remove the bolt and the wheel. Then go
through the same steps in reverse. Do not overtighten
the bolt so as not to damage the plastic.
The rear frame has series of holes
15 mm separated for varying the
height of the seat. To change the po-
sition, unscrew the nut and bolt and change the position
of the bearing to the new hole.
Converting an Minos Plena in a Minos Plena with Drum Brake
Remove the rear wheel, remove the wheel axle, fit into the wheel
axle the drum brake support and fix the drum brake kit. Fit the new
rear wheel on the drum. At the top of the handle, fit the grip extension
and mount the brake handle on the front. Adjust the cable and the
sleeve.
How to apply and release the brake
The chair has two brake handles: one on each backrest handle. To
apply the brake, squeeze the handles gently until the brake slows
down thechair.To release the brake, the handle has one release
mechanism that unlock the brake. When the cable that runs from
the handle to the brake regulator is slack, the travel of the brake
handle will increase. The cable should be sufficiently tight (not too
tight, since that would brake the chair)so as to obtain the correct
braking pressure.
23