KitchenAid KUIX535HBS00 Instrucciones De Instalación página 7

Reversing the Hinges and End Caps
1. Install the hinge screws (placed aside in step 10 of "Door
Panel and Hinge Removal") half way on the desired side of the
cabinet.
2. Take the original top hinge, flip it and place it in the bottom
hinge position on the opposite side. Slide onto the cabinet
hinge screws. The hinge tabs on the hinges should always
face towards each other.
A
A. Hinge tab
3. Take the original bottom hinge, flip it and place it in the top
hinge position on the opposite side. Slide onto the cabinet
hinge screws.
4. Fully tighten the top and bottom hinge screws.
Final Door Placement
NOTE: Before placing the door back on the ice maker, check all
installed parts to ensure there are no exposed screws, all screw
cover caps are on, and the door is facing the correct way with the
stainless steel door facing out.
1. Slide the door onto the hinges. Using Torx T25 screwdriver
install the screws (removed in the step 6 of "Removing the
Hinges" section) onto the door.
2. Reinstall the plastic screw cover to original locations on the
hinges.
3. Reinstall the top and bottom end caps on the door (the top
right end cap is now the bottom left end cap and vice versa).
NOTE: For custom wood install skip this step.
4. Place the steel door panel back on the door once all screws
are tightened. For custom door panel, skip this step.
7