Use Of Remote Control (Remote Watch); Using Remote Control - MINOX ACX 400 Manual De Instrucciones

Use the main switch to navigate and select a file by prolonged pressing on
the shutter release. Pressing the shutter release briefly starts the playback.
A second short press returns you to the start.

6. Use of remote control (remote watch)

The remote control, which has a symbol like a watch, shows a LED as a
status display in the overview below. Directly above the LED is the photo
shutter release (grey key with an indented point), in the centre is the video
shutter release (red key with a raised point) and at the top is the main
switch.
6.1 Establishing the connection
First of all, please activate remote control operation in the camera. (See
Chapter 4.4 General Settings: RF-CTRL). Press the main switch on the
remote control for 3 seconds while the camera is switched on. This estab-
lishes the connection. The LED control light will flash blue.
50

6.2 Using remote control

Photo: Press the photo shutter release once in order to take a single photo.
The LED will flicker twice.
Video recording: Press the video shutter release once in order to start the
recording. The LED will flicker twice. To stop the video recording, press the
video shutter release again.
Switching off: Press the main switch for the remote control and hold it for
3 seconds in order to switch off the camera. The LED control light will like-
wise also switch off.
Main button
Photo capture button
Video capture button
LED status display
51