Features Of The; Air Dehumidifier; Operating Instructions - BIELMEIER BHG 212 Instrucciones De Uso

GB
The air dehumidifier is suitable
for rooms of up to 175 m³ . How-
ever, this information depends
on the temperature and the rela-
tive humidity . The air dehumidi-
fier obtains the highest efficiency
in rooms with high temperature
and humidity .
A relative humidity of 50 % and
below is recommended .
CautIon!
after unpacking the device, let
it rest for about 2 hours before
switching it on.
the cooling circuit needs time
to adjust after transport of the
appliance.
oPeratIon of the

aIr dehumIdIfIer

1 The device cools the incoming
air stream at the back of the
appliance so that part of the
humidity condensates . The
condensation water can either
be collected in the water tank
or directly led to the drain .
2 The reheated air is then blown
out at the top of the device .
3 The appliance offers the
following features:
22
Acoustic and visual signal if

the water tank is full .
Automatic defrost .


features of the

aIr dehumIdIfIer
The device can prevent the for-

mation of mold on clothes and
leather goods .
Open the closet before switch-

ing on the air dehumidifier .
The device can prevent ceilings

and windows from fogging .
Close all windows and doors to

achieve the best results .
The device can decrease hu-

midity of shelves and closets .
For best results, open the closet

and place the back of the dehu-
midifier in front of it .
Use the condensation water:

The water is absolutely clean
which makes it suitable for use
in a steam iron .

oPeratInG InstruCtIons

1 Set up the device and insert the
power plug (220-240 V, 50Hz),
you will hear an acoustic signal .
2 Press the ON/OFF button
( ), the following settings are
selected by default:
6
1
Fan speed 1
2 Fan speed 2
3
Illuminates if no time has been
set (continuous operation)
4
Water tank full
a. fan speed 1 ( )
b. continuous operation ( )
c. humidity 55 %
3 Select the desired settings:
a. Button relative humidity
( ): press the button to
increase the
humidity by 5 % . You will hear
an acoustic signal each time
you press the button . If the
selected target relative humid-
ity has been reached, the com-
pressor stops and only the fan
continues to run . If the humidity
increases again, the compressor
switches on automatically .
The highest target relative humid-
ity is 80 % . If you press ( ) again,
22
3
1 7 2 4 8 5 9
5
Operating indicator light
6 Button relative humidity (%)
7
Button fan speed
8 Button timer
9
Button ON / OFF
the display indicates CO and the
appliance switches to continuous
operation mode . After selecting
the target relative humidity, it
may take about 3 minutes for the
compressor to restart .
b. Button fan speed ( ): press
the button to increase or de-
relative crease the fan speed . You will
hear an acoustic signal each
time you press the button .
High fan speed increases the
dehumidification performance .
c. Button timer ( ): press the but-
ton to increase the automatic
run time by one hour . You will
hear an acoustic signal each
time you press the button . The
selected run time is indicated
on the display . The air dehu-
GB
23