Switching On And Off; Protecting The Environment - Black+Decker KD620 Manual De Instrucciones

16 • ENGLISH
generate a strong recoil, so it would be necessary to hold
the tool tightly with both hands to remain in a stable
position.
Setting the drilling depth (Fig. E)
The depth stop is a convenient feature to ensure
uniformity in drilling depth. Loosen the side handle to
adjust the depth gauge according to the required depth.
After that, tighten the side handle.
f Slacken the side handle (5) by turning the grip
counter clockwise.
f Set the depth stop (6) to the desired position. The
maximum drilling depth is equal to the distance
between the tip of the drill bit and the front end of the
depth stop.
f Tighten the side handle by turning the grip clockwise.

Switching on and oFF

Warning!Before plugging in to the power source, make
sure the switch can be flipped freely, and can return to its
original position once released.
f To switch the tool on, press the variable speed switch
(1). The tool speed depends on how far you press the
switch.
f As a general rule, use low speeds for large diameter
drill bits and high speeds for smaller diameter drill bits.
f For continuous operation, press the lock-on button
(2) and release the variable speed switch.
f To switch the tool o, release the variable speed
switch. To switch the tool o when in continuous
operation, press the variable speed switch once
more and release it.
MAINTENANCE
Keep guards, air vents and the motor housing as clear as
possible of dust and dirt. Wipe with a clean cloth and blow
through with a low-pressure air supply. Excessive build-up
of metal dust can cause tracking of electrical current from
the internal parts to exposed metal parts.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
SPECIFICATIONS
Power input
Voltage
AR
B2C
B3
B2
BR
No-load speed
impact rate
Impact energy
Modes
Max capacity
Concrete
Steel
Wood
Weight
KD620K
620W
220V~50Hz
220V~50-60Hz
120V~60Hz
220V~60Hz
127V~60Hz
0 - 1250/min (rpm)
0 - 3900 gpm (bpm)
1.34J
2
20mm
13mm
25mm
2,6kg