Alarm Functions - ASCOM a71 Guía De Referencia Rápida

Alarm functions

Test alarm
Press and hold the "Alarm" push-button until "Test Alarm" is
displayed.
Note: It is recommended to send a test alarm every day to test
the transceiver and the system.
Personal alarm
Press the Alarm push-button twice within two seconds.
"Personal Alarm" is displayed.
Pull-cord alarm
An alarm is sent when the Pull-cord is pulled off the transceiver.
The Pull-cord is also used as a security string.
Note: Make sure that the clip of the pull-cord is safely attached
to your clothing. To make a test, remove the battery of the
transceiver, pull the transceiver and make sure that the pull-cord
releases first.
Man-down & No-movement alarm
Man-down alarm: The transceiver is tilted more than 55º for a
preset time.
No-movement alarm: Movement is not detected during a pre-set
time.
Before the alarm is sent, the transceiver enters a warning phase
with a repeated warning signal (default seven seconds). Press any
button during this warning phase to prevent the alarm from
being sent.
Note: Man-down & No-movement alarm can temporary be
disabled (default 10 minutes). When the warning signal sounds,
press the "Mute" button. Press "Yes" when "Delay MD/NM
Alarms?" is shown in the display.
Note: If enabled, the ramped up Acoustic Location Signal (ALS)
is played after an alarm. Press the "Mute" button to turn the ALS
off.
a71 versions only
GB
5