Beper 70.254 Manual De Instrucciones página 17

Ice Cream Maker Use instructions
Parts
1 On/off knob
2 Power unit
3 Lid
4 Paddle unit
5 Inner tank
6 Fastening loop
7 Outer tank
8 Fastening buckle
9 Outlet pedestal unit
10 Filling chute
11 Supporter
12 Power cord and plug
1 Install the inner tank into the fastening loop, let
the two grooves match up to the fastening buckle and
rotate it anticlockwise to fasten. Eight hours in advan-
ce, place the installed inner tank into a freezer that is
operating at a temperature of -18° Centigrade ( -0.40°
Fahrenheit) or below. So that you can take out the in-
ner tank by holding the fastening loop easily, and will
not frostbite your fingers.
Hints
If the inner space of freezer is not high enough, only
place the inner tank into the freezer. And then install it
as pictured below before making ice cream.
2 Install the outer tank onto the supporter, It will insert into place.
3 Place the installed inner tank into the outer tank. Make sure the buckle at the back side of the
fastening loop match up to the notch on the back top of the outer tank and the inner tank is installed
properly and stably. The inner tank will be fastened and will not move when the machine is working.
4 Install the power unit into the lid. It will click into place.
5 Install the paddle into the power unit.
Note: Make sure that the paddle with assembled properly. Refer to cleaning of Padd
le
17