Power Button - Artrom DM-10R Manual De Instrucciones

Operation
Continue button
Select for the dehumidifier to operate continuously
for maximum dehumidification until the bucket is
full. The Humdity set control pads cannot be used
when Continuous operation is on. Press this pad
again to cancel Continuous operation and enter
dehumidifying mode.

Power button

Press to turn the dehumidifier on and off. It
illuminates when the unit is switched on and turns
dark when the unit is switched off. When
Humidity/Temperature sensor malfunction occurs,
the power light blinks at 5 times per second.
Down/Up buttons
Humidity Set Control Buttons
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the
percent value(%).
For damper air, press the
higher percent value(%).
22
button and set to a lower
—
button and set a
+