Tabla de contenido
Publicidad
: The working parts of
I M P O R T A N T
the machine are release coated — scraping
with sharp objects or abrasive materials
could damage the machine and may void
any warranties.
: Les plans de travail de
I M P O R T A N T
la machine sont recouverts d'une couche
libre — Gratter avec des outils pointus ou
des matériaux abrasifs pourrait endommager
la machine et peut annuler toute garantie.
: L a s p i e z a s d e l a
I M P O R T A N T
máquina son cubiertas de una capa de
protección — raspar con objetos afilados
o materiales abrasivos podría dañar la
máquina y puede anular las garantías.
/
/
D I A G R A M A
S C H É M A
F I G U R E
/
/
D I A G R A M A
S C H É M A
F I G U R E
V
C L E A N I N G T H E
W A R N I N G
the machine unless you are a trained Key Operator or qualified service tech-
nician . . . Follow all precautions. Always unplug the machine before opening.
Always wear the Heat Protective Glove (included in your Accessory Pack)
when removing a jammed Binderstrip
Under normal operating conditions it is not necessary to clean the inside of
the machine. However, cleaning is necessary when a Binderstrip
or if you see adhesive buildup on an operating part.
Adhesive Buildup
:
N O T E
If you see adhesive build-upon the internal parts of the machine:
A. Turn the Power Switch to "Off " and unplug the machine.
B.
Let the machine cool for approximately 15 to 20 minutes.
C. Clean the affected parts with a cloth dampened with the Cleaning Solution
included in your Accessory Pack. Always wear the Heat Protective Glove.
:
O R
A. Turn the Power Switch to "Off " and unplug the machine.
B.
Let it cool completely — approximately 30 minutes.
C. Peel the adhesive off with your fingers.
Cleaning the Heating Platen
1.
Turn the Power Switch to "Off ", unplug the machine, and follow steps
1 – 5 detailed in "Removing a Jammed Binderstrip
2.
Clean the upper side of the heating platen with a cloth dampened with
the Cleaning Solution provided in your Accessory Pack, or peel the
adhesive off the upper side of the platen with your fingers (or a wooden
5
instrument such as an ice cream stick) (figure 5).
3.
To reach the under side of the heating platen, gently grasp the pully
positioned next to the large black gear and rotate it clockwise until
the lower side of the heating platen is upright (figure 6).
4.
Clean the under side of the heating platen in the same manner as
described in "Step 2".
5.
When finished cleaning, rotate the gear in the opposite direction to
return the heating platen to its original position.
6
M O D E L
1 1 K E Y
I N S I D E
O F T H E
Internal parts can be extremely hot! Do not attempt to open
:
™
.
'
O P E R A T O R
S
M A N U A L
M A C H I N E
™
has jammed
™
.
11
Publicidad
Tabla de contenido
