Danfoss TP9 Instrucciones Del Usuario página 20

Programming heating in 24 hour mode
GB
(one set of programmes for whole week)
1. Press PROG until Event 1 appears in
the top left of the display.
Use the + and - buttons to set the
time you want your heating to fi rst
come on in the morning (Event 1).
Use the
temperature you want your heating
to reach at this time.
2. To move to the next setting, i.e. when
you would like your heating to go
off (Event 2) press the PROG button
again.
Continue programming the central
heating event times & temperatures
by pressing:
a) PROG button to move to the next
setting,
b) + and - buttons to amend the
time,
c)
temperature.
3. Press the PROG button to return the
unit to RUN mode (time appears &
colon in the display begins to fl ash)
4. Proceed to page 23.
20
and buttons to set the
and buttons to amend the