Danfoss TP9 Instrucciones Del Usuario página 23

Programming the Hot Water
To set the hot water programme press the
PROG button until A (1st On) appears on
the display.
Set the hot water programme in the same
way as the heating programme, using:
a) + and - buttons to alter the time,
b) pressing the PROG button to move to
the next setting:
Setting B = 1st Off
Setting C = 2nd On
Setting D = 2nd Off
Finally press PROG to return the unit to
run mode (time appears & colon in the
display begins to fl ash).
GB
23