Tabla de contenido
Publicidad
Placement and installation of the device
•
Before connecting to electricity, make sure that the voltage in your electrical network matches the data
on the type plate.
•
When plugging and unplugging the power cord, hold the plug, never pull the cord itself.
•
When the power cord of the device is plugged into the outlet, the device is under voltage, even when it
is off.
•
Do not place the device in an environment with excessive dust to prevent dirt accumulating on the
player's heads.
•
Humidity condensation: If the unit is moved from a cold to a warm location or used in too wet locations it
may cause condensation in the device, which will negatively affect its performance. In this case, remove
the disc and leave the unit for about 1 hour undisturbed until the moisture evaporates.
Power
Inserting the batteries
1.
Open the battery compartment and insert 6 batteries LR14, UM-2 or C-type (not supplied) with the correct
polarity indicated by the symbols (+) and (-) inside the compartment.
GB
2.
Return the cover of the battery compartment and make sure the batteries are properly and firmly in place.
The device is now ready for use. Battery operation requires unplugging the power cord from the device.
Whenever possible, power the device from the electrical outlet, you will save the batteries life.
Handling the batteries
•
Improper use can cause corrosion or battery leakage and subsequent damage to the device or personal
injury.
•
Observe the polarity of the batteries (+ and - ) marked inside the battery compartment. Use only batteries
recommended in this manual. Do not combine old and new batteries or batteries of various types.
•
Do not throw old batteries in general household waste. Ensure their disposal in accordance with local laws.
AC power supply
1.
Place the device so that the electrical outlet is easily accessible. Check that the local network voltage
corresponds to the values on the type label. Otherwise, contact your vendor or a service center.
2.
Insert the power cord in the AC connector and plug the other end in the electrical outlet. The device is
now ready for use. To completely switch off the appliance, unplug the power cord from the electrical
outlet.
If you want to disconnect the device from electricity, always unplug the power cord from
the electrical outlet. If you would unplug the power cord from the device only and leave it
connected to the network, this could result in serious harm to small children.
USING THE SYSTEM
Listening to the radio
Move the function selector FUNCTION in the AM or FM position.
1.
2.
Turning the control TUNING tune in the desired station.
3.
Set the volume by turning the VOLUME control.
If you want to turn off the radio, switch the selector FUNCTION in the OFF position.
4.
Antenna
For the best hearing of FM radio extend fully the FM antenna and turn it in a position with best reception. The
device is equipped with an integrated AM antenna, to achieve the optimum AM reception turn the whole
device.
36
Publicidad
Tabla de contenido
