Safety Instructions; Using The Appliance - ECG OP 200 Manual De Instrucciones

COSMETIC BRUSH

SAFETY INSTRUCTIONS

Read carefully and save for future use!
Warning: The safety measures and instructions, contained in this manual, do not include all conditions and
situations possible. The user must understand that common sense, caution and care are factors that cannot be
integrated into any product. Therefore, these factors shall be ensured by the user/s using and operating this
appliance. We are not liable for damages caused during shipping, by incorrect use, voltage fl uctuation or the
modifi cation or adjustment of any part of the appliance.
To protect against a risk of fi re or electric shock, basic precautions shall be taken while using electrical
appliances, including the following:
1. Never use the appliance if it is damaged. All servicing should be done by qualifi ed service center!
2. The appliance should not be left unattended when in operation.
3. Do not use the appliance close to a source of heat, e. g. oven. Protect it against direct sunlight.
4. Use accessories only advised by the manufacturer, otherwise you risk losing the warranty.
5. Use this appliance only in accordance with the instructions in this manual. The appliance is designed for
GB
domestic use only. The manufacturer is not liable for damages caused by improper use.
6. Never use the device on sick or infl amed skin!
7. This appliance can be used by children ages 8 and older and by the physically and mentally impaired or
by individuals with insuffi cient experience and knowledge, if supervised or trained to use the appliance in
a safe manner and understand potential dangers. Children shall not play with the appliance. Cleaning and
maintenance operations performed by the user shall not be carried out by children without supervision.
Children under 8 years of age must be prevented from access to the device.

USING THE APPLIANCE

Operation of the cosmetic brush
Make sure that the switch is in the OFF position. Open the cover and insert in the body of the brush 2 × AA
batteries (observe correct polarity).
Feet cleaning
Make sure that the unit is properly fi tted with disc with brush (2). (Do not use without inserted disc)
Switch the device on and gently move the brush over the soles of your feet until all the dirt is gone.
Do not press too hard, you could stop the disc. Using the speed switch (7) you can select low (LOW) or high
(HIGH) rotation speed or by moving in the OFF position switch the device off .
Sanding feet
Change the cleaning disc for a sanding disc. You can choose between the coarse (5) and the fi ne (4) sanding
disc.
Switch the device on and gently move with the disc over the hardened skin, which will gradually abrade until
you reach the desired smoothness. Use only on dry skin.
Wipe the remnants of the abraded skin from your feet.
Dry the feet thoroughly.
Attention: Do not apply to one spot for longer than 3-4 seconds at a time. In case of irritation or redness end
the procedure. Do not press too hard on the skin
Final treatment of the feet
To soften the sanded skin use the head with the sponge. Apply cream on the soles of the feet or on the brush
head and roll it over the feet until the cream is absorbed.
14
Do not immerse in water!