Preparation For Use; Power Supply - Select Sound BT8110 Manual De Usuario

Welcome
Thank you for purchasing the Radio CD/MP3/USB Player BT8110. In order to fully benefit from this
product, please follow the instructions in this user manual very carefully. Store this user manual in a
safe place for future reference. We are sure your new Radio CD/MP3/USB will satisfy your needs

PREPARATION FOR USE

Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit
itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do
not remove any labels located on either the back or button cabinet of the unit.
* Press the CD door OPEN Button to open the CD compartment door. There is a white card in the
CD compartment which is intended to prevent the CD pickup from moving during shipment of the
product, Remove this card from the CD compartment before use.

POWER SUPPLY

Using AC Power
1. Check if the power voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or service center.
2. Connect the power cord to the AC socket inlet and the wall outlet, the power supply is now
connected and ready for use.
3. To switch off completely, unplug the power cord from the wall outlet.
4. Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Batteries (not included)
Open the battery compartment and insert eight batteries, type LR14, UM-2 or C-cells,
(Preferably Alkaline) with the correct polarity as indicated by the"+"and"-" symbols inside the
compartment
Batteries contain chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electronic leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of the same type for the
set. When inserting new batteries, do not try to mix old batteries with new ones.
EN-1