Select Sound BT8110 Manual De Usuario página 18

TROUBLESHOOTING
Troubleshooting
If a fault occurs, it is important you first check the points listed below before taking the unit for repair.
Do not open the unit as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
WARNING: Under no circumstances should you try to repair the unit yourself, as this will
invalidate the warranty.
- Problem
- Solution
No Sound / Power
- Volume not adjusted
- Adjust the Volume level
- Power cord not securely connected
- Connect the AC power cord properly
- Batteries dead/ incorrectly inserted
- Insert new batteries correctly
Display does not function properly.
No reaction to operation of any of the controls
- Electrostatic discharge
- Switch off and unplug the unit. Connect it after a
few seconds
No disc indication
-No CD inserted
- Insert a CD, MP3,CD-R.
-CD badly scratched or dirty
- Replace/clean CD. See Maintenance.
- CD-R is blank or the disc is not finalized
- Use a finalized CD-R.
CD/MP3/USB playback does not work
-CD/MP3/USB badly scratched or dirty
- Replace or clean the CD/MP3/USB
(see maintenance)
-Laser lens steamed up
- Wait until the lens has adjusted to room
temperature.
The CD/MP3 skips tracks
-CD/MP3 damaged or dirty
- Replace or clean CD/MP3
-Program is active
- Quit Program mode(s)
EN-8