Clock Adjustment; Radio Function - Select Sound BT8110 Manual De Usuario

CLOCK ADJUSTMENT

To setup the time of the unit:
1. Connect the AC power cord (The following operation must be done in standby mode).
2. Press the PROG/TIME button to enter into time setting mode. The time will flash on the LCD
display.
3. Press BACK or NEXT button to select the time format by 12h or 24h or adjust the time.
4. After setting the time, press PROG/TIME button to confirm.

RADIO FUNCTION

Radio reception
1. Press the FUNCTION button to select the "RADIO" mode.
2. Tune to the required station by pressing BACK/TUNE DN or NEXT/ TUNE UP
Manual Tuning: Press BACK or NEXT and then release within 1 sec.
Auto Tuning: Press the Play/Pause button to enter the automatic channel search mode.
Preset Channel :( FM 30 Preset memories)
(1) Press the BACK/TUNE-DN or NEXT/TUNE-UP to select the desired station.
(2) Press the PROGRAM button once and the MEMORY number indicator will begin to flash on
the display.
(3) Press the PRESET-UP OR PRESET DOWN buttons to select the desired station number.
(4) Press the PROGRAM button to save the station.
(5) Repeat steps (1) to (4) procedures for storing the rest of the stations.
3. After storing the stations, press PRE-UP or PRE-DN to play the selected frequency.
4. Press [VOL-] or [VOL +] to adjust the volume level.
5. Extend the telescopic antenna to its full length while listening in FM mode and for better
reception.
6. Turn off the radio by pressing the FUNCTION button. Select any other mode or press the power
button to off the unit.
7. The preset memories will be stored even though the unit is switched off and on.
EN-4