Troubleshooting; Problem Solution - BiAL ILS Manual De Usuario

currently set. Settings can be modified as
required while the device is working (but-
tons and ).
If the device was off before the timer mode
was activated, it will turn off automatically
on termination of t he timer.
If the device was set to i.e. setting 2 before
the timer mode was activated, and is then
modified to i.e. setting 4, the device will re-
turn to setting 2 after 2 hours.
Attention: if the device is on and settings
are not modified on activation of TIMER,
settings will not change after 2 hours. It will
still operate on the same setting.

TROUBLESHOOTING

Problem
Device is connected to
electricity, no diodes are
on
Device heats despite hav-
ing been turned off with
{on/off} button
If the problem persists, please contact your local distributor.
EN
Press
TIMER mode. Turning the device off and
back on with the
vate the function.
ANTI-FREEZE FUNCTION
(Anti-freeze protection)
When the device is off and the tempera-
ture around temperature sensor drops to
below 6° C , the device will switch on au-
tomatically. This is to prevent the heating
medium inside the radiator from freezing.
Activating Anti-freeze mode is indicated by
flashing of the centre diode.
Possible cause
Connection problem
Electronics problem
button at any time to stop the
button will also deacti-

Problem solution

Check the mains connec-
tion, check if the power
supply is correct
Disconnect the device
completely from electricity
and wait until the radiator
cools down. Turn the de-
vice back on
15