BiAL ILS Manual De Usuario página 5

nently connected must have the right current differ-
ential and overcurrent relay (R.C.D.) of 30 mA.
An Omni-pole cut-out is required for disconnecting
the device on all poles, via joints positioned at least
3 mm apart.
12. The device equipped with a supplying cable without
plug can be installed in bathrooms in zone 1, as de-
fined by applicable law, subject to any additional regu-
lations concerning electrical installations in wet areas.
Other versions of the device can be installed in Zone 2
or beyond.
13. The device is recommended for use solely as de-
scribed in the manual.
14. Ensure that the heater has been installed on a wall in
accordance with its installation manual.
15. Please forward this instruction manual to the end
user.
EN
5