Technical Specifications - ECG IV 29 Manual De Instrucciones

Keep the hob out of reach of children until it cools!
After cooling, clean the ceramic glass cooktop and the control panel of the hob with a cloth and use a cloth
moistened with dish detergent for more soiled places.
Do not use abrasive sponges or scouring powder. Do not immerse the induction hob and the power cord in
water!
Keep the top of the hob clean all the time to prevent accumulation of dirt around the fan and its possible
failure. Wipe the dust from the area of air circulation openings using cotton buds or a toothbrush with a small
amount of non agressive cleaning detergent and carefully remove oil stains.
Clean carefully the remnants of cleaning agents off the cooktop with damp cloth, otherwise they can burn
when the hob is turned on.
WARNINGS
If the display shows a warning message, follow the instructions below.
Warning code Possible cause
EO
An unsuitable pot/pan is on the
induction zone or the diameter of the
pot/pan is less than 12 cm.
E1
Bad connection of the induction hob/
faulty electrical circuit.
E2
Problem with the temperature sensor. Contact an authorized service center.
E3 Voltage is too high.
E4
Voltage is too low.
E5
Protection against overheating – the
cooktop is too hot.
E6
Problem with the fan, the air intake/
outflow is blocked.

TECHNICAL SPECIFICATIONS

Free-standing or built-in cooktop
Saving time and energy
Minimal heat loss
Suitable for 12–24 cm diameter cookware
Extra large LED display
10-stage temperature control (60°C – 240°C)
10-stage power setting
1–180 minutes timer
Touch control
Automatic safety cut-off ater cookware is set aside
Overheating and surge protection
Power on indicator
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 2900 W
Noise level: <40 dB
Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean the
openings. Afterwards, restart the appliance.
If the problem persists, contact an authorized
service center.
GB
49