Technical Specifications - ECG IV 18 Manual De Instrucciones

Hornillo por inducción
Ocultar thumbs Ver también para IV 18:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
Warning code
E3
E4
E5
E6

TECHNICAL SPECIFICATIONS

Ceramic glass cooktop
Quick heat-up time and energy saving
GB
Minimal heat loss
Suitable for 12–30 cm diameter cookware
Extra large LED display
10-stage temperature control (60 °C – 240 °C)
10-stage power setting (200–1800 W)
1 to 180 minute timer
Touch control
Automatic safety cut-off after cookware is set aside
Overheating and surge protection
Power on indicator
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1800 W
Noise level: <40 dB
USE AND DISPOSAL OF WASTE
Wrapping paper and corrugated paperboard – deliver to scrapyard. Packing foil, PE bags, plastic elements – throw into
plastic recycling containers.
DISPOSAL OF PRODUCTS AT THE END OF LIFETIME
Disposal of electric and electronic equipment (valid in EU member countries and other European
countries with an implemented recycling system)
The represented symbol on the product or package means the product shall not be treated as domestic waste.
Hand over the product to the specifi ed location for recycling electric and electronic equipment. Prevent
negative impacts on human health and the environment by properly recycling your product.
Recycling contributes to preserving natural resources. For more information on the recycling of this product,
refer to your local authority, domestic waste processing organization or store, where you purchased the
product.
This product complies with EU directive requirements on electromagnetic compatibility and
electrical safety.
The instruction manual is available at website www.ecg.cz.
Changes in text and technical parameters reserved.
32
Possible cause
Voltage is too high.
Voltage is too low.
Protection against overheating – the
cooktop is too hot.
Problem with the fan, the air intake/
outfl ow is blocked.
Solution
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean the
openings. Afterwards, restart the appliance.
If the problem persists, contact an authorized
service center.
08/05

Publicidad

Tabla de contenido
loading

Tabla de contenido