Assembly Of Qanto; General Assembly Instructions; Delivery - Ninka Qanto Instrucciones De Uso

EN

5. Assembly of Qanto

5.1 General assembly instructions

Anyone who performs connection or assembly work on Qanto or uses Qanto
must have access to these instructions for use. Follow these instructions.
Non-observance of the above mentioned instructions can lead to accidents
resulting in severe personal injury.
If the product is visibly damaged, it must not be installed.
During the installation of Qanto, make sure there is sufficient clearance for
the movement of the lifting system. When Qanto is extended upward and to
both sides, a clearance of about 200 mm to other cabinets or shelving must
be observed.
A clearance of 300 mm must be observed between Qanto and a gas stove.
The electrical system of Qanto must be accessible (e.g., a double socket
under the cabinet near the base).
Make sure the cables are undamaged.
Before connecting Qanto to the power mains, you must check whether the
voltage on the control unit is correct.
If the control unit causes unusual noises or odours during operation, interrupt
the power supply.

5.2 Delivery

1x
1x 4x 5x 1x (2x)
8 - EN
Qanto_Id_A5_0000.50 65060_EN 26042018