Installing The Tool On The Motor - AXXAIR CC-X22 Serie Instrucciones De Manejo

INNOVATIVE ORBITAL SOLUTIONS
The arrow indicates the tool's direction of rotation.
The hole positions the cutter and avoids all
excessive clamping during usage.

7. Installing the tool on the motor:

WARNING: The motor should always be disconnected from the power supply.
These tools are sharp; appropriate gloves should therefore be used when installing and uninstalling the
cutting tools.
Note: All support surfaces should always be cleaned.
- Place the blade in such a way that the direction of rotation shown on the tool corresponds to the
direction of rotation of the cutter's motor. With this type of tool we always counterwork, i.e. the
direction of rotation of the tool is the opposite to the direction of rotation of the forward motion.
Place the disc over the blade, ensuring that the pin is correctly positioned.
-
Note: The pin is not a driving bolt; it's used to prevent the blade from over-tightening during usage
and to allow easy uninstalling and changing of the blade.
If the cutting tool used does not have a hole, mount the support disc with the pin toward the exterior.
-
Put the nut in place and tighten with the key provided for that purpose. It needs to be tightened hard
-
(by tapping the key) to keep the tool from loosening.
Note: The brass nut (yellow) tightens counter clockwise, the direction of tightening and loosening is
therefore reversed in comparison to a normal thread.
On our cutting heads, we can install a two-sided tool with an angle head.
It is strongly recommended that the machine be used with the tool installed as close as possible to the
clamping jaws in order to limit vibration and thus lengthen the life of the tools. Exterior installation allows
trimming the elbow joints and other joints after a faulty soldering at the tip of the tube.
Join experience
ENGLISH
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 16 -