Penetration Adjustments; Cutting Step By Step - AXXAIR CC-X22 Serie Instrucciones De Manejo

INNOVATIVE ORBITAL SOLUTIONS

12. Penetration adjustments:

Put the blade in its working position. The index plunger of the penetration lever in the screw head
-
on the steel plate (Fig.01).
Move the tube forward to the edge of the clamping jaws so that it is slightly back in relation to the
-
tool. Clamp the tube to ensure a good geometry of the adjustments (Fig.02).
Loosen the knurled screw of the penetration lever (Fig.03) and swivel the tool support plate
-
(Fig.04) so that the top teeth of the cutting tool protrude from 1 to 2 mm into the interior of the
tube (Fig.05).
- Retighten the knurled screw of the penetration lever (Fig.03) when the adjustments are done.
Lift back up the penetration lever to disengage the cutting tool (Fig.06).
-
- This adjustment is necessary each time you change tube diameter and/or thickness.
Fig.01
Fig.04

13. Cutting step by step:

Warning: Always check that the tube does not
bump up against the saw blade when it is put
into the cutting machine and that it is correctly
aligned with the cutting machine.
Before starting the cutting motor, make sure that
there are no foreign bodies left in the cutting
area.
- Tightening the hold on the tube (1).
Starting the cutting motor (2).
-
- Penetration into the tube (3).
Rotating around the tube (4).
-
- Disengaging from the tool after the cut is
made (3).
- Stopping the cutting motor (2)
Loosening the hold on the tube.
-
The cut is finished.
Join experience
ENGLISH
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Fig.02
Fig.05
Direction of advancement of
the cutting tool
2
3
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 20 -
Fig.03
Fig.06
4
1