Start-Up Instructions - Haier WDNS32BW Manual Del Usuario

3. Fill water tank with tap water full to capacity, wait 5 minutes until water settles.
4. Activate the child safety button and press the hot water lever until water starts
to come out, then stop.
5. Plug the dispenser into the electrical socket.
6. Press the hot water switch (back of unit) to the ON position, the switch should
be lit.
A. Press the cold water switch (back of unit) to the ON position, the switch should
be lit.
B. Wait for the hot water to reach temperature in approximately 10 minutes
C. Wait for the cold to reach temperature in other 40 minutes approximately.
7. Press the hot and cold water switch to turn them OFF and unplug the dispenser
from the electrical outlet.
8. Drain the water by pressing hot water button and then cold water button, until
no more water remains (to facilitate this operation, use a large container).
9. Drain any water left in the tanks by opening the drain cap located on the back
side of the dispenser, until the water drains completely. Please remember to
close the drain cap firmly after the drainage.
10. Place a 5 gallon or 3 gallon bottle of water onto the water intake of the
dispenser; allow water to stand for approximate one minute.
11. Push water faucet buttons to insure water flows from both faucets.
12. Plug the dispenser into the electrical socket.
13. Now you are ready to use your water dispenser.

START-UP INSTRUCTIONS

Read carefully and understand all installation instructions before
installing the water dispenser.
1. Remove the cap from the water bottle first. Lift up the water bottle and quickly
place it into the water receptacle. (The water bottle is not included.)
2. DO NOT plug in the water dispenser until you have checked that
water flows out of both faucets when the hot and cold water
release levers are pressed. Never turn on the water dispenser
without water. Doing so may cause the unit to catch fire or
malfunction.
3. Check that water flows out by pressing both the hot and cold water faucets
one at a time.
4. Plug the power cord into an 115volt / 60 Hz outlet.
5. To activate the water heater and cooler, press the hot water and cold water
switches to the ON position, the switches should be lit.
English
6