LEGRAND 430 570 Manual De Usuario página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.
Connection under various signal input mode
a. Connecting with DVR
Make sure the MONITOR set and DVR have been turned off.
Connect the AV BNC input jacks of the monitor set to correspondingly signal output interface of the
DVR.
Plug the male end of the AC adaptor to the MONITOR set and another end to the 100~240V 50/60Hz
AC power source.
Switch on the MONITOR set by pressing "POWER" button and then the DVR.
Press the "SELECT" button on the front control or "SOURCE" button on the remote control to switch to
C-Video1 or C-Video 2/Decoder input mode.
b. Connecting with computer
You can enjoy high-definition interface and sounds once you connect the MONITOR set to computer.
Make sure the monitor set and computer main unit have been turned off
Connect the D-SUB 15 pin VGA plug of the unit to the computer's
Plug the male end of the AC adaptor to the MONITOR set and another end to the 100~240V 50/60Hz
AC power source.
Switch on the monitor set by pressing "power" button and then computer.
Press the "SELECT" button on the front control or " Source" button on the remote control to switch to
RGB input mode.
16

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

430 571

Tabla de contenido