GB Intsruments Wire-Tracker GET-4110K Manual De Instrucciones página 2

Wire Tracing
The Wire Tracker™ (GET-4110K) and
LAN Tracker™ (GET-4220K) are
designed to trace a variety of
unenergized wires. Each unit comes
with a transmitter and a receiver.
Under perfect conditions, the receiver
will function up to 12" from the wire
being traced. Results will vary based
on factors such as insulation type,
proximity to other bundled wire, etc.
This is normal, and is true of all wire
tracing devices on the market.
Transmitter
The transmitter contains five (5)
adapters for connection to common
wiring applications.
GET-4110K
RJ-11 Plug
Co-axial Plug
Two (2) Alligator Clips
Automotive Fuse Plug
PUSH
ON
AUTO
OFF
GET-4110T
Transmitter
1
GET-4220K
RJ-11 Plug
Co-axial Plug
Two (2) Alligator Clips
RJ-45 Plug
To access the adapters, open the
back of the transmitter. All five plugs
are contained in individual slots.
During use, the appropriate plug can
be pulled out of the slot, and the
cover closed. The On/Off button is
located on the front of the housing.
To activate the unit, press this button
once. The LED will blink, indicating
that a signal is being transmitted.
The unit can be turned off by
pressing this button again.
To conserve battery life, the unit will
turn itself off after 30 minutes.
PUSH
ON
AUTO
OFF
GET-4220T
Transmitter
2