Battery Replacement - GB Intsruments Wire-Tracker GET-4110K Manual De Instrucciones

Trace the wiring as described above.
You may notice that the receiver must
be contacting the LAN wire and is
stronger along one side of the wire.
This is normal and is due to the
physical properties of the LAN cable,
which is designed to prevent
interference from external signals.
Tracing Other Unenergized
Wiring
Make sure all wiring is
! WARNING WARNING
disconnected from any
power source.
To trace a single wire, connect the red
lead alligator clip to the wire to be
traced. To boost the signal, connect
the black lead alligator clip to a
suitable ground. Two wires can be
traced at the same time by connecting
one alligator clip to each wire;
however, the signal will not be as
strong as it is while tracing a single
wire with the black alligator clip
connected to ground. Trace the wiring
as described above.
7

Battery Replacement

The Transmitter uses two (2) AAA
batteries. To replace them, open the
transmitter case and identify the
battery compartment on the left.
Remove the cover and replace the
batteries, noting the polarity shown
on the cover.
The Receiver uses four (4) button cell
batteries (LR44). To replace them,
locate the battery cover at the back
of the tester. Push the cover off to
expose the batteries. Replace with
new batteries, noting the polarity
shown in the battery compartment.
8