Cleaning And Maintenance; Technical Specifications - ECG KT 10 Manual De Instrucciones

Using the device for heating
1. Turn the functions switch to "I" position for lower output, or to "II" for full heating output.
2. Turn the thermostat control to set the desired temperature. Turning counterclockwise will lower the
temperature, turning clockwise will increase the temperature.
3. When the set temperature is reached, the thermostat will switch the heater off and when the temperature
drops below the set level, it will switch it on again.
4. To achieve maximum heating output, turn the switch to "II" and turn the thermostat control fully to the
right.
5. To distribute the heat around the room evenly, press the "SWING" button.
Overheating
• The device will be switched off by internal thermal fuse in case of overheating.
• Overheating could be caused by covering the ventilation openings on the rear of the appliance or by
covering the grill in front. When that happens, unplug the appliance from the outlet and let it cool for
30 minutes. Remove all obstacles and switch the appliance on again.
• If the device stops working, the likeliest cause is a blown fuse. Please, contact an authorized service
center.

CLEANING AND MAINTENANCE

• Before cleaning unplug the appliance from the outlet and let it cool thoroughly.
• NEVER use water for cleaning the device and protect it from contact with water under all circumstances.
• The outer cover can be cleaned using slightly damp cloth (if necessary use weak solution of mild
detergent).
• You can use regular vacuum cleaner to remove dust from behind the front grill or from the rear ventilation
openings.
• Always make sure that the device is completely dry before using it.
• If you will not use the device for a longer period of time, it is best to clean it and when completely dry,
store it in a plastic bag in a cool and dry place.
• With good handling, this ceramic heaters can bring many years of reliable and economic heating.

TECHNICAL SPECIFICATIONS

Option to set 90° oscillation
2 stage power setting (750 / 1500 W)
Cool air function
Safety function automatic switch-off when tipped over
Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 1500 W
Noise level: <50 dB
GB
31