Safety In Use; Troubleshooting - Manusa SMART-PROX Manual De Instrucciones

D00146EN - v3
8 - SAFETY IN USE: INTENDED USES AND USES TO BE AVOIDED
The instructions in the manual of the automatic door on which this control element is fitted are always complementary to and
an extension of the warnings regarding this control element.
The uses listed below are prohibited and must be avoided:

Do not modify the detector or any of its components.

Do not allow children to play with the detector.

Do not disconnect the door's safety components, manipulate them or remove them from service.

Only use original replacement parts provided by Manusa.

Do not use the detector as a support element.

Only technicians authorised by Manusa may open and manipulate the inside of the detector and its connections.
This list takes into account the possible unintended uses of the detector. Nevertheless, Manusa accepts no responsibility for
possible accidents or damage caused by undue uses not stated above .

9 - TROUBLESHOOTING

Malfunction
Red LED is blinking
Blue led does not light when ap-
proaching hand to the unit
NOTE: The characteristics indicated in this document are purely
informative, and not in any way contractual.
The manufacturer reserves the right to make modifications without prior
notice.
Last revision: October 2013
TOUCHLESS SWITCH SMART-PROX - INSTRUCTIONS MANUAL
Possible cause
Microswitch S1 in wrong position
Wrong wiring or power failure
CENTRAL OFFICES
Av. Vía Augusta, 85-87, 6th
08174 Sant Cugat del Vallés
Barcelona - Spain
Tel. +34 902 321 400
Fax +34 902 321 450
11
Suggested action
Correct microswitch S1 position
according to chapter 6.
If there is no power failure, check
wiring according to chapter 5.
FACTORY
Ctra. Pla de Sta. María 235-239
43800 Valls - Tarragona (Spain)
Tel. +34 902 321 700
Fax +34 902 321 750
www.manusa.com