Oven Functions - ECG MTD 2590 GBS Manual De Instrucciones

INSTALLATION OF THE TURNTABLE TRAY
Hub (bottom side)
Turntable
Support axis
INSTALLATION
Remove all packaging material and take out all accessories.
Make sure the oven is not damaged in any way (dented or damaged door etc.). Do not install the microwave oven if damaged.
Kitchen worktop
Oven body: Remove all protective foil from the oven surface.
Do not remove the rectangular cover that is attached inside the
oven. This cover protects the magnetron of the oven.
Installation
1. Place the oven on a at surface with a su cient amount of space
around the appliance to ensure the proper function of exhaust
vents.
There must be a minimum distance of 10 cm between the back of
the oven and the wall. There must be at least 5 cm of free space on
the sides.
a) Leave at east 20 cm of free space above the oven.
b) Do not remove oven legs.
c) Do not block exhaust vents. Blocking the exhaust vents could cause damage.
d) Place the oven as far away from the radio or television as possible.
The microwave oven can interfere with the television and radio signal.
2. Connect the oven to a standard electricity network. Make sure the voltage and frequency on the oven label corresponds with the
network voltage and frequency.
WARNING: Do not install the oven above or near the kitchen stove, or near another source of heat. Placing the oven by
a heat source could damage the oven and result in losing the warranty. The microwave oven should be used in an open
space and should not be placed in a cabinet.
The surface of the microwave oven can become hot during operation.

OVEN FUNCTIONS

Operating instructions
This microwave oven uses modern electronic controlling to con gure cooking parameters to better meet your needs.
If you press during cooking the PAUSE/CANCEL button, the program pauses, you can resume by pressing the button START/QUICK START.
When you press again the PAUSE/CANCEL button, the program is cancelled. When the cooking is completed, a beep sounds and END will
appear on the display.
1. Setting the time
As soon as the microwave oven is plugged into the socket, "1:00" shows on the oven display and a beep sounds.
Press the button WEIGHT/CLOCK for 3 seconds to set the time. Press repeatedly to select 24 hour (Hr 24) or 12 hour (Hr 12) mode.
MTD 2590 GBS_manual_cz_sk_pl_hu_de_gb_hr_si_sr_fr_it_es_et_lt_lv.indb 75
1. Never place the glass tray upside down The turntable must always rotate freely.
2. Do not use the oven without the turning ring and the glass tray.
3. All foods and dishes with food must be always placed on the glass tray.
4. If the glass tray breaks or the turning ring is damaged, contact your nearest
authorized service centre.
Assembled support
20 cm
10 cm
Opening
5 cm
GB
Hot surface!
75
31.05.2018 15:36:23