Oregon LM400 Manual De Instrucciones página 14

Operation (Fig. G)
First, make sure you are in the proper cutting
area Ensure the cutting area is free of bystanders
and foreign objects Inspect the machine for any
possible damage or unsafe conditions
Ensure the cutting height of the machine is at your
desired height
Ensure the safety key points toward one battery
position
Press and hold the safety button (1), squeeze the
switch lever (2) towards the handlebar (Fig. G)
When the unit starts, release the safety button
(1) Maintain squeezing the switch lever with two
hands during use
Releasing the switch lever will disengage power
to the unit The blades may continue to rotate for
a period of time after power is disengaged
Stopping the Machine (Fig. H)
Release the switch lever (1) (Fig. H) Releasing
the switch lever will disengage power to the unit
The blades may continue to rotate for a period of
time after power is disengaged
Using Rear Bagging (Fig. I - J)
Assemble the debris bag by inserting the metal
frame into the soft mesh bag (1) and connecting
the plastic clips from the soft mesh bag to the
metal frame (2) (Fig. I)
To attach the debris bag to the machine, lift and
hold the discharge cover (1) with one hand, and
with the opposite hand, place the two hooks (2)
from the debris bag onto the metal shaft (3) on
each side of the discharge cover (Fig. J) Release
the spring loaded discharge cover, allowing the
cover to collapse over the opening between the
debris bag and the machine
14
Assembly
Using the Side Discharge (Fig. K)
First, take the debris bag off In a slight downward
angle, position the front and rear hooks of the
discharge chute onto the metal pin of the side
cover (1) (Fig. K) Rotate the chute down causing
the hooks to lock in place (2) Release the side
cover with your hand, check the chute is properly
in place
Using the Mulching Plug (Fig. L)
Lift the discharge cover and remove the debris
bag (1) (Fig. L) Hold the discharge cover with
one hand, and with the opposite hand, place the
mulching plug in the rear discharge chute (2)
Release the spring loaded discharge cover
Replacing or Sharpening
the Cutting Blade
WARNING: Always remove the battery
and the safety key when performing any
maintenance.
The cutting blade is designed to be a replacement
item and may need sharpening from time to time
Sharpen when dull Replace when damaged
Contact your dealer or the manufacturer for proper
instructions
Storage (Fig. M - N)
Pull and twist the knob on the left side of the unit,
so that the knob rests on the handle (1) On the
opposite side , with one hand pull the knob (2) and
with the other hand pull down the handle to the
front of the lawnmower (3) (Fig. L) Then, lift the
machine from the front until it rests safely on the
rear frame of the machine (Fig. M)
Lawnmower Model LM400