Connecting the rain sensor
IMPORTANT
►
A jumper
always be inserted if you are not connecting a rain sensor,
otherwise the programmed watering cannot take place.
GB
►
If the jumper is lost, you can bend a new jumper into shape
MT
using standard commercial wire or a paperclip.
NOTICE
►
An example of a compatible rain sensor is the Kärcher rain
sensor no. 2.645-037. You should also observe the operat-
ing instructions for the rain sensor.
►
Please also note that structural changes to the rain sensor
connecting plug will result in the loss of warranty.
♦
Push the two levers for unlocking the terminals
remove the jumper
♦
Insert the cable ends of the rain sensor into the terminals
and then clamp them fi rmly by pushing the two levers back
down again.
58
7
is inserted in the terminals
.
7
8
on delivery. It must
8
upwards and
8
FBC 7 A1