Rear Panel Features; Top Panel Features; Front Panel Features - Akiyama ACORDE Manual De Usuario

REAR PANEL FEATURES

1 .
AC power cord
This power cable should be plugged into a wall receptable,After all audio connections are made.
2 .
POWER ON / OFF SWITCH
TurnsACORDE on or off.
3 .
RCAAUDIO OUTPUT CABLES
These cables should be plugged into the audio inputs of your home stereo system.
Note: you can still copy records to your USB device or SD card, even, if the audio outputs of the
turntable are not connected to a stereo system

FRONT PANEL FEATURES

4 .
USB SLOT
Insert USB Pendrive or connect USB hard disk (FAT16 or FAT32 only) to this input.
USB: 1.1, support 64MB - 16GB.
Note: ACORDE does not support USB hubs
5 .
SD CARD SLOT
Insert SD card into this slot until it clicks. To eject it, push it in once until it clicks, then remove it from
the slot.
SD: 64MB - 2GB ; SDHC: 4GB - 16GB.
Note: ACORDE can only recognize one connected device (USB drive or SD card) at a time
3
.

TOP PANEL FEATURES

6 .
33 / 45 SPEED BUTTON
This button controls the RPM of the turntable motor.
7 .
LCD
Shows information pertinent to unit operation.
8 .
PLAY / PAUSE
Press this button to play. While playing, press again to pause. While paused, play again to resume
playback.
9 .
STOP
Press this button to stop playback or recording.
10 .
TRACK
Skips to the previous track or next track. Press and hold the button down to rewind or fast forward
throught the currect track.
11 .
REC
Press this button to enter record mode. Record Mode allows you to record music from the turntable platter
Press button for 45 rpm. Depress button for 33 rpm.