Sears Craftsman Z6000 Serie Manual Del Operador página 17

2. To turn to the left while traveling in reverse, move the left drive control lever
forward of the right lever. See "Figure 14".
Rearward Left Turn
3. To turn to the right while traveling in reverse, move the right drive control
lever forward of the left lever. See "Figure 15".
4. The greater the fore-to-aft distance between the two levers, the sharper the
riding mower will turn.
5. To execute a zero turn, move the turn side drive control lever to the neutral
position, while moving the other control lever rearward.
NOTE: Making a zero turn while the vehicle is moving will greatly increase
the potential for defacement of the turf. For turf protection and to avoid
personal injury, always stop the vehicle before executing a zero turn.
Figure 14
Rearward Right Turn
Figure 15
OPERATION
Reverse Caution Mode (If equipped)
The REVERSE CAUTION MODE
tractor to be operated in reverse with the blades (PTO) engaged.
NOTE: Mowing in reverse is not recommended.
WARNING! Use extreme caution while operating the tractor in
the REVERSE CAUTION MODE
before and while backing. Do not operate the tractor when children
or others are around. Stop the tractor immediately if someone
enters the area.
To use the REVERSE CAUTION MODE
NOTE: The operator MUST be seated in the tractor seat.
1. Start the engine as instructed on the previous page.
2. Turn the key from the NORMAL MOWING
the REVERSE CAUTION MODE
switch module. See "Figure 16".
Indicator
Light
Stop
Position
3. Press the REVERSE PUSH BUTTON
top, right corner of the key switch module. The red indicator light at the top,
left corner of the ignition switch module will be ON while activated. See
"Figure 16".
4. Once activated (indicator light ON), the tractor can be driven in reverse with
the cutting blades (PTO) engaged.
5. Always look down and behind before and while backing to make sure no
children are around. After resuming forward motion, return the key to the
NORMAL MOWING
The REVERSE CAUTION MODE
a. The key is placed in either the NORMAL MOWING
b. The operator leaves the seat.
17
position of the key switch module allows the
. Always look down and behind
:
(Yellow) position of the ignition
Figure 16
(Orange, Triangular Button) at the
position.
will remain activated until:
position or
(Green) position to
Reverse
Push Button
Reverse
Caution Mode
Position
Start
Position
position or STOP