Sears Craftsman Z6000 Serie Manual Del Operador página 32

Problem
Engine overheats
Engine hesitates at high
RPMs
Engine idles poorly
Excessive vibration
Uneven cut
TROUBLESHOOTING
Cause
1. Engine oil level low
2. Air flow restricted
1. Spark plug gap set too close
1. Fouled spark plug
2. Dirty air cleaner
1. Cutting blades loose or unbalanced
2. Damaged, dull, or bent cutting blade
1. Deck not leveled properly.
2. Dull blade.
3. Uneven tire pressure.
1. Fill engine with proper amount and type of oil.
2. Clean grass clippings and debris from around the
engine's cooling fins and blower housing.
1. Remove spark plug and adjust gap.
1. Replace spark plug and adjust gap.
2. Clean or replace air cleaner element and/or clean
pre-cleaner.
1. Tighten blade and spindle. Balance blade.
2. Replace blade.
1. Perform side-to-side deck adjustment.
2. Sharpen or replace blade.
3. Check tire pressure in all four tires.
32
Remedy