Noise/Vibration Information - Skil 7232 Manual De Instrucciones

fers to the illustration of the machine on the
graphics page.
A On/Off switch
B Clamping wire
C Sanding plate
D Clamping lever
E Sanding sheet
Technical Data
Orbital sander
Article number
W
Rated power input 127 V
W
220 V
Frecuency Hz
No-load speed /min
No-load orbital /min
stroke rate
Orbit diameter mm
Sanding sheet mm
dimensions
Sanding plate mm
dimensions
Weight according to kg
EPTA-Procedure 01/2003
Protection class
Please observe the article number on the
type plate of your machine. The trade names
of the individual machines may vary.

NOISE/VIBRATION INFORMATION

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 82 dB(A);
Sound power level 93 dB(A). Uncertainty
K=3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) de-
termined according to EN 60745:
Vibration emission value ah =6.5 m/s², Un-
certainty K =2.0 m/s².
The vibration emission level given in this in-
formation sheet has been measured in ac-
cordance with a standardized test given in
EN 60745 and may be used to compare one
tool with another.
It may be used for a preliminary assessment
of exposure.
The declared vibration emission level repre-
sents the main applications of the tool. How-
ever if the tool is used for different applica-
tions, with different accessories or poorly
maintained, the vibration emission may dif-
fer. This may significantly
increase the exposure level over the total
working period.
Skil 7232
An estimation of the level of exposure to
vibration should also take into account the
F 012 7232...
times when the tool is switched off or when
200
it is running but not actually doing the job.
200 This may significantly reduce the exposure
50/60 level over the total working period.
14000 Identify additional safety measures to pro-
tect the operator from the effects of vibration
28000
such as: maintain the tool and the accesso-
ries, keep the hands warm, organization of
1,6
work patterns.
114 x 140
Assembly
114 X 103
Before any work on the machine itself,
1,4
pull the mains plug.
/II
REPLACING THE SANDING SHEET
When attaching a new sanding sheet, re-
move any dust or debris from the sanding
plate C (e. g. with a brush).
SANDING SHEETS WITHOUT VELCRO
BACKING (SEE FIG. 2)
1.
To open clamping wire, lift clamping lever
out of it's pocket and then lower lever so it is
positioned as shown in (Fig. 2).
2.
Place the abrasive sheet (grit side up)
between the clamping wire and base plate
while aligning edges of the abrasive sheet
with either edge of the pad. (Pre-bending the
sheet makes attachment easier.)
3.
After inserting the sheet, raise clamping
lever and return it to it's original position
making sure the clamping wire is secure.
4.
Wrap the sheet around the length of the
pad and attach free end of sheet under
opposite clamp and repeat procedures 1, 2,
& 3 above.
16