Cleaning And Maintenance - A.I.&.E HA-35 Manual De Instrucciones

given supervision or instruction concerning safe use of the appliance and understand the hazards
involved. Children must not play with the appliance. Cleaning and user maintenance must not be
carried out by children without supervision.
26. If the power cable is damaged, it must be replaced by the manufacturer, their service agent or
similarly qualified persons in order to avoid hazards.
INSTRUCTIONS FOR USE
1. Put the plug into the power socket.
2. The heater has two power settings: 350W and 700W.
3. Turn the control knob to the left for operation without the oscillation function: LOW (350W) or HIGH
(700W).
4. Turn the control knob to the right for operation with the oscillation function:
or (oscillation + 700W).
5. Fig. 2 shows the angle knob with two angle modes: 120° and 360°. When using the oscillation
function, turn the angle knob left for 120° movement and right for 360° movement.
6. Switch the heater off by turning the control knob to the OFF position.
7. Remove the plug from the power socket.
Fig. 1

CLEANING AND MAINTENANCE

1. Remove the plug from the power socket before cleaning the appliance.
2. Use a slightly damp cloth to clean the housing of the appliance, do not use chemical agents (alcohol,
acetate, gasoline etc.).
3. If the heater is not going to be used for a long time, make sure that it is wrapped in a plastic bag and
put in a dry place when it has completely cooled and dried.
(oscillation + 350W)
Fig. 2