Airmec BRICO Serie Manual De Instrucciones página 18

SETTING IN MOTION - SWITCHING OFF
After carrying out the above mentioned
controls, connect the compressor to the
electric installation and switch the button onto
the "ON-1" position (fig. 5) . To switch off the
compressor push the button to "OFF-0"
position (fig. 5).
In CHB models the oil level is to be checked
through the transparent tap. The oil level
has to correspond to the red mark on the
tap (fig. 3.1) .
WARNING
To switch off the compressor always
use the button on the air pressure
switch; if you switch off the
compressor by unplugging it, the
pressure in the head of the
compressor would be prevented from
flowing out, and this could cause
difficulties when using the
compressor again.
Do not pull the cable to unplug the
compressor and avoid placing the
compressor in cold environments.
It is advisable not to use extensions
of any kind during normal operation
of the compressor.
The functioning of the compressor is
adjusted by the air pressure switch (fig. 5),
which interrupts network supply when the
pressure inside the tank reaches the set
value (8 bar) and reconnects the
compressor to the system when the
pressure reaches a level 2 bar inferior to
the set maximum level.
GB
fig. 3.1
fig. 4
fig. 5
18