Airmec BRICO Serie Manual De Instrucciones página 22

MAINTENANCE
After switching off the compressor,
it does not start again
■
unplug the compressor;
■
rotate the fan to make sure that the
system is not blocked;
■
wait a few minutes before restarting the
compressor.
As regards the model CH 210, when the
compressor overheats a temperature
control device is released, and the
compressor cuts out for a few seconds
(15-20 sec).
The compressor starts again when as soon
as the compressor has colled down.
The CHB pump has a temperature control
device with a button (fig. 11) . If the device
is released, push the button to restart the
motor.
If the motor does not start, please contact
an authorised shop.
■
The condenser is damaged.
GB
The compressor is noisy and gives out
rhythmical and metallic sounds
Stop the engine immediately and contact
specialised technicians.
fig. 11
22