Gabarron IGMBMA-K3DNB7I Manual De Usuario página 32

Operation of Remote Controller
10 TIMER ON :
Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply
press this button again.
After pressing this button,
setting. Within 5 seconds, press + or - button to adjust the time value. Every press of either
button changes the time setting by 1 minute. Holding down either button rapidly changes the
time setting by 1 minute and then 10 minutes. Within 5 seconds after setting, press TIMER
ON button to confirm.
:
11
Press this button to set up & down swing angle, which circularly changes as below:
This remote controller is universal. If any command
the unit will carry out the command as
indicates the guide louver swings as:
12
X-FAN:
Pressing X-FAN button in COOL or DRY mode, the icon
fan will continue operation for 2 minutes in order to dry the indoor unit even though you
have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or
HEAT mode.
NOTE: X-FAN is the alternative expression of BLOW for the purpose of understanding.
13
TEMP:
Press this button, you can see indoor set temperature, indoor ambient temperature
on indoor unit's display. The setting on remote controller is selected circularly as below:
When selecting "
unit displays set temperature; When selecting
indicator on indoor unit displays indoor ambient temperature;
receives other remote control signal that will return to display the setting temperature.
Caution:
•
This model hasn't outdoor ambient temperature display function. While remote controller
can operate "
• It's defaulted to display set temperature when turning on the unit.
•
Only for the models with temperature indicator on indoor unit.
14 TIMER OFF :
Press this button to initiate the auto-off timer. To cancel the auto-timer program, simply
press the button again.TIMER OFF setting is the same as TIMER ON.
15
TURBO:
Press this button to activate / deactivate the Turbo function which enables the unit to
reach the preset temperature in the shortest time. In COOL mode, the unit will blow strong
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed. (This function is not applicable for some models).
disappears and "ON "blinks . 00:00 is displayed for ON time
OFF
no display
" with remote controller or no display, temperature indicator on indoor
"and indoor unit displays set temperature.
,
" " with remote controller, temperature
-10-
or is sent out,
is displayed and the indoor
3s later or within 3s it