VERIGA SNOW Manual De Usuario página 10

Dear customer,
Thank you for your trust in our chains and
congratulations on your good choice. We have done our
best to ensure that the use of our chains is simple and
reliable.
All our materials are of the highest quality and treated in
the modern computer-controlled heat-treating furnace.
Which gives us guarantee for optimal surface toughness.
To ensure the longest possible life span of our chains, the
design allows usage on both sides of their work surface
(except for Star Extreme and Maxi Grip models). We
suggest that you always mount the chains the way that
their most worn-out side is facing the tire.
WARNING: If the chainlinks are worn-out by more than
50% of their original state, we advise you against using
the chains. In this case, our product warranty is void.
We suggest you avoid sudden acceleration and
stopping. The maximum driving speed with mounted
chains is 50 km/h.
17
1. Spread out the chain behind the tire so that its running
surface is on the upper side and the tensioning chain is on
the outside of the wheel. Tighten the mounting chain over
the tire. (Figure P 01)
2. Fasten the end of the chain to the mounting chain.
(Figure P 02)
3. Slowly move your vehicle backwards or forwards just
enough, for the ends of the chain to meet.
(Figure P 03-1 – P 03-2)
4. Attach the inner hook of the chain to the last ring.
(Figure P 04-1)
Fastening according to the thickness of the chain.
Does not apply to TRACTOR.
a) chain thickness 4,5 mm – 8 mm. (Figure P 00-A)
b) chain thickness 9,5 mm – 12 mm. (Figure P 00-B)
Fasten the inner part of the chain so that the chain is
appropriately tensioned. Leave some links unfastened, if
necessary. Only applies to Tractor. (Figure P 04-2)
5. Attach the outer hook of the chain to the last ring.
(Figure P 05-1)
Fastening according to the thickness of the chain.
Does not apply to TRACTOR.
a) chain thickness 4,5 mm – 8 mm. (Figure P 00-A)
b) chain thickness 9,5 mm – 12 mm. (Figure P 00-B)
Fasten the outer part of the chain so that the chain is
appropriately tensioned. Leave some links unfastened, if
necessary. Only applies to Tractor. (Figure P 05-2)
18