Ama 3 Manual Del Usuario página 28

50:55:34 N
005:26:31 E
SPEED:0.00
OUTPUT OFF/ON
If you fill in the coordinates on our website
"Standard Format" , push the "OK"-button. Now the location of your vehicle will be visualized.
4. GPS-CHECK FUNCTION
Attention:The first time after installing the AMA3, it can take about 10 minutes before AMA3 has
got sufficient satellite information to operate properly
Each time the ignition key is turned on, the GPS-receiver starts collecting satellite data. This can take
up to 2 minutes to collect the satellite information it needs. You can check if you have GPS signal.
Activating the GPS check-function
Turn on the ignition key and hold the push button (this can last for 10 seconds) until you hear two
buzzer signals. The test can be done while driving the vehicle. Each time AMA3 receives a valid GPS-
signal you'll hear 2 short buzzer signals. When the GPS-signal is OK, you will hear them every 3
seconds
.
Deactivating the GPS check-function
There are 2 different ways to do it:
1) Turn OFF the ignition key.
2) Hold the push button (this can last for 10 seconds), until you hear 1 long buzzer signal.
27
www.amasystems.be
.
, choose your language and go to