Displays And Buttons; Setting The Time; Using The Stopwatch - Lotus ILMJS10 Manual De Instrucciones

I
ENGLISH INSTRUCTION MANUAL
A) DISPLAYS AND BUTTONS
24 Hour Hand
Stopwatch Minutes Hand
Stopwatch Second Hand
B) SETTING THE TIME
1. Pull the crown out to the 1st Click Position.
2. Turn the crown to set hour and minute hands.
C) USING THE STOPWATCH
This stopwatch is able to measure and display time in 1/1 second united up to maximum of 30 minutes.
Stopwatch will stop automatically after running continuously for 30 minutes.
Measuring time with the stopwatch
1. Press button "A" to start the stopwatch.
2. The stopwatch can be started and stopped each time button "A" is pressed.
3. Pressing button "B" resets the stopwatch and stopwatch minute and second hands return to their ZERO positions.
RESET
D) STOPWATCH RESET (incl. After replacing battery)
This procedure should be performed when the stopwatch second hand does not return to the ZERO second position.
1. Pull the crown out to the 1st Click Position.
2. Press button "A" to set the stop watch second hand to the ZERO position.
* The stopwatch minute hand is syncronized with stopwatch second hand.
* The stop watch second hand can be advanced rapidly by continuously pressing button "A".
3. Once the hands have been zeroed, reset the time and return the crown to its normal position.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
Button A
Button A
TIME MEASUREMENT
ILMJS10
Normal Position
1st Click Position
Second Hand
STOP