Product Disposal - BATSI MIE210TIC Manual De Uso

INTRODUCTION
This instruction manual has been written by the controller manufacturer and is an exclusive part
of the product. The operations contained are addressed to properly trained and qualifi ed per-
sonnel. It is recommended to be read and stored for future reference.
TERMS OF USE
BATSI® recommends the installation of all devices, equipment and materials, complying with
European Directives 2006/42 / EC (Machinery Directive), 2014/30 / EU and subsequent modifi ca-
tions (low voltage electrical equipment). Non-EU countries, in addition to existing national stan-
dards and for a suffi cient level of safety, it is also recommended to comply with the indications
contained in the above Directives.

PRODUCT DISPOSAL

In accordance with the EU Directive 2012/19 / EU on Waste Electrical and Electronic Equipment
(WEEE), this electronic product can not be disposed of with other unclassifi ed waste. Dispose of
this equipment by returning it to a local collection point for recycling.
MIE 210TIC MODULE OPERATION MODE
The MIE 210TIC count the working time and it can show the following information:
Partial working time (can be reset).
Total working time (can be reset).
Global working time (cannot be reset).
STARTING TO WORK WITH MIE 210TIC MODULE
The MIE 210TIC needs a validation to starting to count the working time.
You have to follow those steps to activate the counter:
1- Connect the module to a power supply.
2- Wait until the message "PRESS BUTTON TO START" appears in the screen.
3- Push the button
Optionally, the module activation can be done through a sensor (consult the manufacturer). In
this case:
1- Connect the module to a power supply.
2- The sensor has to detect a machine part.
.
4