Waeco SinePower MSP 162 Instrucciones De Uso página 27

_MSP160_MSP350.book Seite 27 Montag, 5. November 2007 4:49 16
SinePower
Caution
a
Only extend the connection line with cables with a cross section
that is equal to or greater than that of the connection line.
Caution
e
Do not reverse the polarity. Reversing the polarity of the connec-
tions will cause a great spark and the internal fuses will melt. These
fuses should only be replaced by a qualified electrician.
7.3 Connecting external switches
Note
I
Connect the external switch to the inverter using a connection
cable with Western telephone jack. Observe the PIN configuration
on the plug for the connection cable.
➤ Cut the connection cable to size according to the wiring diagrams or have
the device connected up by a specialist.
– External switch, voltage supply from the inverter: fig. 4, page 5
– Control unit with relay or semiconductor circuit (TR): fig. 5, page 5
– External switch with voltage supply from the battery (BAT) of the
vehicle: fig. 6, page 5
– External switch with it own voltage supply (DC POWER) e.g. from the
ignition: fig. 7, page 5
➤ Connect the external switch with the connection cable on the remote port
(fig. 2 4, page 4).
Connecting the inverter
27