Using The Kettle - Roadstar HK-400G Manual De Instrucciones

• Make sure that the voltage indicated on the rating plate (located
on the underside of the kettle) is the same as the supply voltage in your home. If not, do
not use the kettle and return it to your dealer.
• After the kettle has switched off automatically, there may be a short delay before it can be
re-boiled - this is usually no more than 20 seconds.
• The safety cutout will operate if you accidentally switch your kettle on when it is empty.
Wait 15 minutes for the cutout to reset before refilling with cold water.
• Never immerse the kettle or base in water (or any other liquid) and do not allow water to
penetrate its electrical parts to prevent electrical hazards.
• Ensure that the kettle and its mains cable are kept out of the reach of children and pets.
Close supervision is necessary when this appliance is used near children.
• The outside surface will get very hot during use. Always take care when handling your
• Always ensure that the kettle is switched off before removing from the base unit.
• Beware of steam being emitted from the spout or lid, especially during refilling.
• This kettle is intended for normal household use only.
• This kettle is intended for boiling water only, nothing else.
• It must not be used for anything other than its intended purpose.
• Do not use this appliance outside.
• Do not insert any objects into holes or slots in this appliance.
• This appliance must not be placed on or near any objects that heat up (such as a gas
or electric hob).
• Do not allow the mains lead to hang over the edge of the work surface, touch sources
of heat or become knotted.
• Do not operate this appliance if the mains lead or plug are damaged, or if the appliance
malfunctions or is damaged in any way. Check the mains lead regularly for signs of
damage.
• No user-serviceable parts inside - refer to qualified service personnel.

USING THE KETTLE

NOTE:
Before first use, fill with water to the maximum mark, bring to the boil
and discard - this will ensure that your kettle is perfectly clean.
Place the supplied descaling filter fixing the hooks in the spout, by sliding it down in the
location and pressing gently from the top to hook it on.
Filling
WARNINGS!
Always remove the kettle from the base before filling.
English
3
Do not overfill as boiling water may be ejected from the spout.
To fill the kettle remove it from the base.
Lift the lid. Fill to the desired level between the MIN (0.5 liter) and MAX (1,7 liter) marks on the
water gauge.
Close the lid by pressing firmly until you hear a click and place back on the base.
Switching On
To switch the kettle on, push the On/Off switch (D) up. The Power Indicator (G) will light.
Switching Off
When the water has boiled the kettle will switch off automatically. You can stop the boiling process
kettle.
at any time by pressing the On/Off switch down.
WARNING!
Never open the lid if steam is coming from the spout.
FEATURES
A. Spout
B. Lid
C. Descaling filter
D. Power On/Off Switch
E. Water Level Gauge
F.
G. Push to open the lid
Position the kettle on a stable flat
surface out of the reach of children and
close to a mains supply socket.
The underside of the base of the kettle
has a cable storage feature as shown
in Fig. 1. Unwind the length of cable
required to reach the mains socket.
Push the cable into one of the three
available slots in the base so that the
base will sit flat on the work surface.
English
4
Base A
C
B
G
D
E