Metabo HPT ET 36A Manual De Instrucciones página 6

English
6. During use, if the machine stops running after the Box's LED lamp blinks, confi rm the
power supply environment.
7. Do not drag the cord when using or carrying the machine.
Doing so may tear the cord insulation or break the cord which could result in electric shock.
8. Do not stretch the cord out any more than required.
When using tools such as gardening clippers or circular saws, always make sure of the
power cord's position to avoid cutting the cord during operation.
9. To use the AC/DC adapter after it shuts down due to high temperature, disconnect the
box's power plug, wait for the LED lamp to go out and then reconnect the box's power plug.
If the machine cuts off even after suffi ciently cooling it off with the built-in fan, discontinue
use as there may be a problem with the machine.
10. Do not use this product near a radio. Doing so could cause noise from the radio, making it
diffi cult to listen to a broadcast.
11. This is a power source for multi volt products. Do not use with 18 V products or chargers.
Doing so could result in damage.
12. Overload behavior may diff er when compared with BSL36B18 battery use.
With the battery where the LED should blink on the main unit, the LED on the AC/DC
adapter may blink instead.
PRECAUTIONS FOR AC/DC ADAPTER
The adapter equips with the protection function to stop the output. In the cases of 1 to 2
described below, when using this product, even if you are pulling the switch, the motor may
stop. This is not the trouble but the result of protection function.
1. If the tool is overloaded, output may stop. In this case, release the switch of tool
and eliminate causes of overloading.
2. If the adapter is overheated under overload work, output may stop. In situations
like this, discontinue use of the adapter and detach it from the tool. Allow the
adapter to cool in a location such as a shaded area with good air circulation.
SAVE THESE INSTRUCTIONS
MAKE THEM AVAILABLE TO
OWNERS OF THIS TOOL!
6
AND
OTHER USERS
AND