Waring Commercial The BIG STIX WSB50E Manual De Instrucciones página 4

With unit unplugged, align the tube assembly to Power Pack and turn it a
quarter of a turn to lock into place. Follow arrows on the tube assembly.
OPERATION:
1. Plug unit into outlet.
2. Plunge the Immersion Blender into the pot. DO NOT SUBMERGE MORE
THAN 3/4 OF THE SHAFT LENGTH.
3. The Immersion Blender has 2 switches to operate the unit. The safety
switch is located on the top of the handle and the power trigger switch
is located on the inner handle. To start unit, press the safety switch and
the power trigger switch simultaneously. The safety switch will only need
to be pressed once to start the unit. The immersion blender will continue
running without holding the safety switch or power trigger switch. In
order to stop the unit from running, the power trigger found on the side
of the handle will need to be depressed.
4. Select the desired speed by turning the speed knob. Speed ranges from
1, the lowest speed, to 9, the highest speed.
5. Use the cord wrap knob as a second handle for stability and safety.
6. Angle the Immersion Blender slightly and start to stir while keeping the
blade off the bottom of the pot so that preparation will not be sucked up
by the vortex action.
7. Remove the Immersion Blender from the pot after blender has come to
a complete stop.
NOTE: Always unplug Immersion Blender after each use. Keep the
appliance out of reach of children.
• To prevent splattering, be careful never to remove the Immersion
Blender from liquid while in operation.
• When a recipe calls for ice, use crushed ice (not whole cubes) for
best results.
NOTE: If a piece of food becomes lodged in the protective blade guard
surrounding the metal blade, follow the safety instructions below:
1. Release the power trigger and unplug the unit from the electrical outlet.
2. Remove the shaft from the Power Pack.
3. Use a spatula to carefully remove the food lodged in the blade guard.
The blade is very sharp. DO NOT USE YOUR FINGERS TO REMOVE
LODGED OBJECTS.
4. You may now reattach shaft, plug unit back in, and continue blending.
THE WSB50E/WSB55E/WSB60E/WSB65E/WSB70E IMMERSION
BLENDERS MUST BE CLEANED AND DRIED AFTER EACH USE,
ACCORDING TO THE FOLLOWING INSTRUCTIONS.
ASSEMBLY
4