Beper 70.402 Manual De Instrucciones página 10

Essential Oil Diffuser Use instructions
Mist output adjustment:
The mist emitted is cold therefore there is no danger of burns.
You can adjust the mist intensity, or omit by using the appropriate switch.
Attention:
In case of absence or lack of water the product will automatically turn off.
The intensity of the mist may vary depending on the temperature of the room and the amount of water in the tank.
Never use the product with mist function without water.
Cleaning: Fig.3
After 5-6 uses, it is recommended to clean the product as follows:
Disconnect the product from the power outlet and remove the cover.
Remove any residual water and / or essential oil by sliding it through the drain side, opposite to the air outlet, to
avoid damaging to the appliance.
Place one teaspoon of vinegar in the tank and 140 ml of warm water in the tank and leave for 5 minutes.
Empty the tank using the drain side, opposite to the air outlet, to avoid damaging to the appliance.
Dry with a soft cloth, while the ultrasonic base can be cleaned with a stick for ears cleaning.
Technical data:
Tank capacity: 140ML
Power: 15.6W
Power supply: DC 24V output 650mA - Input: 110-240V - 50 / 60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
10