We recommend you start with a low flow to
•
avoid condensation and increase this if neces-
sary.
If there is insufficient water in the tank, the indi-
•
cator light (A) will light up red and steam gene-
ration will stop. It will be necessary to refill the
tank with water.
When you want to stop the appliance from emi-
•
tting steam, press the mist regulator button (A)
several times till it goes off.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Unplug the appliance from the mains.
•
Remove the water from the water tank.
•
Clean the appliance.
•
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the electrical equipment and the mains
•
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive pro-
ducts, for cleaning the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
Never submerge the connector in water or any
•
other liquid or place it under running water.
Ceramic balls filter (I): Remove it from the
•
appliance and clean it by placing it under the
tap.
If the appliance is not in good condition of clean-
•
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
Then dry all parts before its assembly and sto-
•
rage.
There may be some scale deposits in the
•
transducer (F), particularly in areas with hard
water:
Overcome this drawback by cleaning the trans-
•
ducer (F).
Rub down with a dry cloth and remove remains
•
of moisture.
Do not place the transducer directly under the
•
tap.
Do not rub the transducer with hard or metal
•
objects.
Do not clean with chemical products.
•
HOW TO DEAL WITH LIME SCALE INCRUS-
TATIONS:
For the appliance to work correctly it should be
•
kept free of limescale or magnesium incrusta-
tions caused by the use of hard water.
To prevent this kind of problem, we recom-
•
mend the use of water with low lime or magne-
sium mineralisation.
However, if it is not possible to use the kind of
•
water recommended above, you should perio-
dically remove the limescale from the applian-
ce:
Every 6 weeks if the water is "very hard".
•
Every 12 weeks if the water is "hard".
•
A specific anti-lime scale product should be
•
used on this kind of product.
Fill the tank with water plus the anti-lime pro-
•
duct, leave about 30 minutes, drain and clean
with water.
Homemade solutions are not recommended in
•
the decaling of this appliance, such as the use
of vinegar.
RECOMMENDATIONS
Never leave water in the base or in the tank.
•
Note: Water accumulated over long periods
•
may create bacteria and mildew (fungus).
Dry all the parts inside the appliance carefully,
•
paying particular attention to the transducer.
Store the appliance in a cool, dry place.
•
EN